Step 1 - Base install
Dig a hole that is approximately 400mm wide and 900mm deep. Place the base in hole and fill hole with concrete. Ensure that 15–20mm of the ring is exposed above the above ground level. This must remain 15–20mm higher than your finished ground level including pavers, grass, tiles etc. Once ready to install the umbrella, grease the outside of the pole and the top of the ring to make sure your umbrella can slide on and then rotate freely.
Step 2 - Placing umbrella
Once the base is correctly installed, then position your umbrella upright and lower it over the pole of the base. The bottom of your umbrella should rest on the base ring. Then rotate the umbrella in its desired position
Step 3 - Locking the umbrella
To lock the umbrella in its position, place your provided winding handle into the lower hex nut on the rear of the frame and rotate it clockwise until it is firmly secure.
